l2bd¶
eth2p-avf-dot1qip4-l2bdbasemaclrn-dev¶
IPv4 routing with IEEE 802.1Q test cases
[Top] Network Topologies: TG-DUT1-TG 2-node circular topology with single links between nodes.
[Enc] Packet Encapsulations: Eth-IPv4 for IPv4 routing. IEEE 802.1Q tagging is applied on links between TG-DUT1.
[Cfg] DUT configuration: DUT1 is configured with IPv4 routing and two static IPv4 /30 route entries. DUT1 is tested with virtual.
[Ver] TG verification: Test IPv4 packets are sent in one direction by TG on link to DUT1; on receive TG verifies packets for correctness and drops as applicable.
[Ref] Applicable standard specifications: IEEE 802.1q.
|
|
|---|---|
|
PASS |
eth2p-ethipv4-l2bdbasemaclrn-dev¶
L2 bridge-domain test cases
[Top] Network Topologies: TG-DUT1-TG 2-node circular topology with single links between nodes.
[Enc] Packet Encapsulations: Eth-IPv4 for L2 switching of IPv4. Both apply to all links.
[Cfg] DUT configuration: DUT1 is configured with L2 bridge-domain switching.
[Ver] TG verification: Test IPv4 packets with IP protocol=61 are sent in both directions by TG on links to DUT1; on receive TG verifies packets for correctness and their IPv4 src-addr, dst-addr and MAC addresses.
[Ref] Applicable standard specifications: RFC792
|
|
|---|---|
|
PASS |
eth2p-ethipv4-l2bdbasemaclrn-iacl1sf-dev¶
L2BD test cases with ACL
[Top] Network Topologies: TG-DUT1-TG 2-node circular topology with single links between nodes.
[Enc] Packet Encapsulations: Eth-IPv4 on all links.
[Cfg] DUT configuration: DUT1 is configured with L2 bridge domain and MAC learning enabled.Required ACL rules are applied to input paths of both DUT1 intefaces.
[Ver] TG verification: Test IPv4 packets are sent in one direction by TG on link to DUT1; on receive TG verifies packets for correctness and drops as applicable.
[Ref] Applicable standard specifications:
|
|
|---|---|
|
PASS |
eth2p-ethipv4-l2bdbasemaclrn-iacl1sl-dev¶
L2BD test cases with ACL
[Top] Network Topologies: TG-DUT1-TG 2-node circular topology with single links between nodes.
[Enc] Packet Encapsulations: Eth-IPv4 on all links.
[Cfg] DUT configuration: DUT1 is configured with L2 bridge domain and MAC learning enabled.Required ACL rules are applied to input paths of both DUT1 intefaces.
[Ver] TG verification: Test IPv4 packets are sent in one direction by TG on link to DUT1; on receive TG verifies packets for correctness and drops as applicable.
[Ref] Applicable standard specifications:
|
|
|---|---|
|
PASS |
eth2p-ethipv4-l2bdbasemaclrn-macip-iacl1sl-dev¶
L2BD test cases with ACL
[Top] Network Topologies: TG-DUT1-TG 2-node circular topology with single links between nodes.
[Enc] Packet Encapsulations: Eth-IPv4 on all links.
[Cfg] DUT configuration: DUT1 is configured with L2 bridge domain and MAC learning enabled.Required MACIP ACL rules are applied to input paths of both DUT1 intefaces.
[Ver] TG verification: Test IPv4 packets are sent in one direction by TG on link to DUT1; on receive TG verifies packets for correctness and drops as applicable.
[Ref] Applicable standard specifications:
|
|
|---|---|
|
PASS |
eth2p-ethipv4-l2bdbasemaclrn-oacl1sf-dev¶
L2BD test cases with ACL
[Top] Network Topologies: TG-DUT1-TG 2-node circular topology with single links between nodes.
[Enc] Packet Encapsulations: Eth-IPv4 on all links.
[Cfg] DUT configuration: DUT1 is configured with L2 bridge domain and MAC learning enabled.Required ACL rules are applied to input paths of both DUT1 intefaces.
[Ver] TG verification: Test IPv4 packets are sent in one direction by TG on link to DUT1; on receive TG verifies packets for correctness and drops as applicable.
[Ref] Applicable standard specifications:
|
|
|---|---|
|
PASS |
eth2p-ethipv4-l2bdbasemaclrn-oacl1sl-dev¶
L2BD test cases with ACL
[Top] Network Topologies: TG-DUT1-TG 2-node circular topology with single links between nodes.
[Enc] Packet Encapsulations: Eth-IPv4 on all links.
[Cfg] DUT configuration: DUT1 is configured with L2 bridge domain and MAC learning enabled.Required ACL rules are applied to input paths of both DUT1 intefaces.
[Ver] TG verification: Test IPv4 packets are sent in one direction by TG on link to DUT1; on receive TG verifies packets for correctness and drops as applicable.
[Ref] Applicable standard specifications:
|
|
|---|---|
|
PASS |