ip4 tunnels¶
eth2p-ethip4–ethip4udpgeneve-1tun-ip4base-dev¶
L2BD with GENEVE L3 mode test cases
[Top] Network Topologies: TG-DUT1-TG 2-node circular topology with single links between nodes.
[Enc] Packet Encapsulations: Eth-IPv4 between TG-if1 and DUT1-if1 and Eth-IPv4-UDP-GENEVE-Eth-IPv4 between DUT1-if2 and TG-if2 for IPv4 routing over GENEVE tunnel.
[Cfg] DUT configuration: DUT1 is configured with IPv4 routing over GENEVE tunnel and 4 static IPv4 /24 route entries. DUT1 is tested with virtual.
[Ver] TG verification: Test Eth-IPv4 packet is sent by TG-if1 on link to DUT1-if1; on receive by TG-if2 the encapsulated packet is verified for correctness and its outer and inner IPv4 and MAC addresses, UDP ports and GENEVE vni and protocol number. Then test Eth-IPv4-UDP-GENEVE-Eth-IPv4 packet is sent by TG-if2 on link to DUT1-if2; on receive by TG-if1 decapsulated packet is verified for correctness and its IPv4 and MAC addresses
[Ref] Applicable standard specifications: RFC791, RFC768, RFC8926.
|
|
|---|---|
|
PASS |
eth2p-ethip4vxlan-l2bdbasemaclrn-dev¶
L2BD with VXLANoIPv4 test cases
[Top] Network topologies: TG-DUT1-TG 2-node circular topology with single links between nodes.
[Enc] Packet encapsulations: Eth-IPv4-VXLAN-Eth-IPv4-ICMPv4 on TG-DUT.
[Cfg] DUT configuration: DUT1 is configured with L2 bridge-domain switching combined with MAC learning enable. VXLAN tunnels are configured on links betwen TG and DUT.
[Ver] TG verification: Test Eth-IPv4-VXLAN-Eth-IPv4-ICMPv4 packet is sent by TG on link to DUT1; on receive TG verifies packets for correctness and their IPv4 src-addr, dst-addr and MAC addresses.
[Ref] Applicable standard specifications: RFC7348.
|
|
|---|---|
|
PASS |
eth2p-ethip4vxlan-l2xcbase-dev¶
L2XC with VXLANoIPv4 test cases
[Top] Network topologies: TG-DUT1-TG 2-node circular topology with single links between nodes.
[Enc] Packet encapsulations: Eth-IPv4-VXLAN-Eth-IPv4-ICMPv4 on TG-DUT.
[Cfg] DUT configuration: DUT1 is configured with L2 cross-connect. VXLAN tunnels are configured on links betwen TG and DUT.
[Ver] TG verification: Test Eth-IPv4-VXLAN-Eth-IPv4-ICMPv4 packet is sent by TG on link to DUT1; on receive TG verifies packets for correctness and their IPv4 src-addr, dst-addr and MAC addresses.
[Ref] Applicable standard specifications: RFC7348.
|
|
|---|---|
|
PASS |
lisp¶
eth2p-ethip4lisp-ip4base-dev¶
ip4-lisp-ip4 encapsulation test cases
[Top] Network Topologies: TG-DUT1-TG 2-node circular topology with single links between nodes.
[Enc] Packet Encapsulations: Eth-IPv4-LISP-IPv4-ICMPv4 on DUT1-TG, Eth-IPv4-ICMPv4 on TG-DUTn for IPv4 routing over LISPoIPv4 tunnel.
[Cfg] DUT configuration: DUT is configured with IPv4 routing and static routes. LISPoIPv4 tunnel is configured between DUT1 and TG2.
[Ver] TG verification: Test ICMPv4 Echo Request packets are sent by TG on if1 link to DUT1; on receive TG verifies packets for correctness and their IPv4 src-addr, dst-addr and MAC addresses.
[Ref] Applicable standard specifications: RFC6830.
|
|
|---|---|
|
PASS |
eth2p-ethip4lispgpe-ip4base-dev¶
ip4-lispgpe-ip4 encapsulation test cases
[Top] Network Topologies: TG-DUT1-TG 2-node circular topology with single links between nodes.
[Enc] Packet Encapsulations: Eth-IPv4-LISPGPE-IPv4-ICMPv4 on DUT1-TG, Eth-IPv4-ICMPv4 on TG-DUTn for IPv4 routing over LISPoIPv4 tunnel.
[Cfg] DUT configuration: DUT1 and TG(if2) are configured with IPv4 routing and static routes. LISPoIPv4 tunnel is configured between DUT1 and TG.
[Ver] TG verification: Test ICMPv4 Echo Request packets are sent in TG->DUT(if1); On receive TG(if2) verifies packets for correctness and their IPv4 src-addr, dst-addr and MAC addresses.
[Ref] Applicable standard specifications: RFC6830.
|
|
|---|---|
|
PASS |
eth2p-ethip4lispgpe-ip6base-dev¶
ip4-lispgpe-ip6 encapsulation test cases
[Top] Network Topologies: TG(if1)-DUT1-TG(if2) 2-node circular topology with single links between nodes.
[Enc] Packet Encapsulations: Eth-IPv4-LISPGPE-IPv6-ICMPv6 on DUT1-TG(if2),Eth-IPv6-ICMPv6 on TG-DUTn for IPv6 routing over LISPoIPv4 tunnel.
[Cfg] DUT configuration: DUT1 and TG(if2) are configured with IPv6 routing and static routes. LISPoIPv4 tunnel is configured between DUT1 and TG(if2).
[Ver] TG verification: Test ICMPv6 Echo Request packets are sent in if1 by TG on links to DUT1; on receive TG verifies packets for correctness and their IPv6 src-addr, dst-addr and MAC addresses.
[Ref] Applicable standard specifications: RFC6830.
|
|
|---|---|
|
PASS |