3n-icx-e810xxv
25ge2p1e810xxv-ethip4ipsec1000tnlsw-fixtnlip-ip4base-policy-aes256gcm-mrr
IPv4 IPsec tunnel mode performance test suite.
[Top] Network Topologies: TG-DUT1-DUT2-TG 3-node circular opology with single links between nodes.
[Enc] Packet Encapsulations: Eth-IPv4 on TG-DUTn, Eth-IPv4-IPSec on DUT1-DUT2.
[Cfg] DUT configuration: DUT1 and DUT2 are configured with multiple IPsec tunnels which shared same tunnel src and dst ip address. DUTs get IPv4 traffic from TG, encrypt it and send to another DUT, where packets are decrypted and sent back to TG.
[Ver] TG vefication: In MaxReceivedRate tests TG sends traffic at line rate and reports total received packets over trial period. Test packets are generated by TG on links to DUTs. TG traffic profile contains two L3 flow-groups (flow-group per direction, number of flows per flow-group equals to
umber of IPSec tunnels) with all packets containing Ethernet header, IPv4 header with IP protocol=61 and static payload. MAC addresses are matching MAC addresses of the TG ode interfaces. Incrementing of IP.dst (IPv4 destination address) is applied to both streams.
[Ref] Applicable standard specifications: RFC4303 and RFC2544.
|
|
|---|---|
|
|
|
|
|
|
|
|
|
|
|
|
25ge2p1e810xxv-ethip4ipsec1000tnlsw-fixtnlip-ip4base-policy-flow-dir-aes256gcm-mrr
IPv4 IPsec tunnel mode performance test suite.
[Top] Network Topologies: TG-DUT1-DUT2-TG 3-node circular opology with single links between nodes.
[Enc] Packet Encapsulations: Eth-IPv4 on TG-DUTn, Eth-IPv4-IPSec on DUT1-DUT2.
[Cfg] DUT configuration: DUT1 and DUT2 are configured with multiple IPsec tunnels which shared same tunnel src and dst ip address, enabled IPsec_ESP flow director between them.DUTs get IPv4 traffic from TG, encrypt it and send to another DUT, where packets are decrypted and sent back to TG.
[Ver] TG vefication: In MaxReceivedRate tests TG sends traffic at line rate and reports total received packets over trial period. Test packets are generated by TG on links to DUTs. TG traffic profile contains two L3 flow-groups (flow-group per direction, number of flows per flow-group equals to
umber of IPSec tunnels) with all packets containing Ethernet header, IPv4 header with IP protocol=61 and static payload. MAC addresses are matching MAC addresses of the TG ode interfaces. Incrementing of IP.dst (IPv4 destination address) is applied to both streams.
[Ref] Applicable standard specifications: RFC4303 and RFC2544.
|
|
|---|---|
|
|
|
|
|
|
|
|
|
|
|
|
25ge2p1e810xxv-ethip4ipsec1000tnlsw-fixtnlip-ip4base-policy-flow-rss-aes256gcm-mrr
IPv4 IPsec tunnel mode performance test suite.
[Top] Network Topologies: TG-DUT1-DUT2-TG 3-node circular opology with single links between nodes.
[Enc] Packet Encapsulations: Eth-IPv4 on TG-DUTn, Eth-IPv4-IPSec on DUT1-DUT2.
[Cfg] DUT configuration: DUT1 and DUT2 are configured with multiple IPsec tunnels which shared same tunnel src and dst ip address, enabled flow rss action between them.DUTs get IPv4 traffic from TG, encrypt it and send to another DUT, where packets are decrypted and sent back to TG.
[Ver] TG vefication: In MaxReceivedRate tests TG sends traffic at line rate and reports total received packets over trial period. Test packets are generated by TG on links to DUTs. TG traffic profile contains two L3 flow-groups (flow-group per direction, number of flows per flow-group equals to
umber of IPSec tunnels) with all packets containing Ethernet header, IPv4 header with IP protocol=61 and static payload. MAC addresses are matching MAC addresses of the TG ode interfaces. Incrementing of IP.dst (IPv4 destination address) is applied to both streams.
[Ref] Applicable standard specifications: RFC4303 and RFC2544.
|
|
|---|---|
|
|
|
|
|
|
|
|
|
|
|
|