Make sure you have gone through Downloading and Installing VPP on the system you want to create containers on.
After VPP is installed, get root privileges with:
$ sudo bash
Then install packages for containers such as lxc:
# apt-get install bridge-utils lxc
As quoted from the lxc.conf manpage, “container configuration is held in the config stored in the container’s directory. A basic configuration is generated at container creation time with the default’s recommended for the chosen template as well as extra default keys coming from the default.conf file.”
“That default.conf file is either located at /etc/lxc/default.conf or for unprivileged containers at ~/.config/lxc/default.conf.”
Since we want to ping between two containers, we’ll need to add to this file.
Look at the contents of default.conf, which should initially look like this:
# cat /etc/lxc/default.conf lxc.network.type = veth lxc.network.link = lxcbr0 lxc.network.flags = up lxc.network.hwaddr = 00:16:3e:xx:xx:xx
As you can see, by default there is one veth interface.
Now you will append to this file so that each container you create will have an interface for a Linux bridge and an unconsumed second interface.
You can do this by piping echo output into tee, where each line is separated with a newline character \n as shown below. Alternatively, you can manually add to this file with a text editor such as vi, but make sure you have root privileges.
# echo -e "lxc.network.name = veth0\nlxc.network.type = veth\nlxc.network.name = veth_link1" | sudo tee -a /etc/lxc/default.conf
Inspect the contents again to verify the file was indeed modified:
# cat /etc/lxc/default.conf lxc.network.type = veth lxc.network.link = lxcbr0 lxc.network.flags = up lxc.network.hwaddr = 00:16:3e:xx:xx:xx lxc.network.name = veth0 lxc.network.type = veth lxc.network.name = veth_link1
After this, we’re ready to create the containers.
Creates an Ubuntu Xenial container named “cone”.
# lxc-create -t download -n cone -- --dist ubuntu --release xenial --arch amd64 --keyserver hkp://p80.pool.sks-keyservers.net:80
If successful, you’ll get an output similar to this:
You just created an Ubuntu xenial amd64 (20180625_07:42) container. To enable SSH, run: apt install openssh-server No default root or user password are set by LXC.
Make another container “ctwo”.
# lxc-create -t download -n ctwo -- --dist ubuntu --release xenial --arch amd64 --keyserver hkp://p80.pool.sks-keyservers.net:80
List your containers to verify they exist:
# lxc-ls cone ctwo
Start the first container:
# lxc-start --name cone
And verify its running:
# lxc-ls --fancy NAME STATE AUTOSTART GROUPS IPV4 IPV6 cone RUNNING 0 - - - ctwo STOPPED 0 - - -
Here are some lxc container commands you may find useful:
$ sudo lxc-ls --fancy $ sudo lxc-start --name u1 --daemon $ sudo lxc-info --name u1 $ sudo lxc-stop --name u1 $ sudo lxc-destroy --name u1