l2bd

eth2p-avf-dot1q-l2bdbasemaclrn-gbp-dev

L2BD with IEEE 802.1Q and GBP test cases

  • [Top] Network Topologies: TG-DUT1-TG 2-node circular topology with single links between nodes.

  • [Enc] Packet Encapsulations: Dot1q-IPv4 for L2 switching of IPv4. IEEE 802.1Q tagging is applied on both links TG-DUT1 .

  • [Cfg] DUT configuration: DUT1 is configured with: 2 VLAN subinterfaces (VID 200 and 300), 1 L2 BD with the 2 VLAN subinterfaces and a BVI, 1 GBP L3 RD, 1 GBP L2 BD with the L2 BD, 1 GBP EPG EPG-1 with sclass 100, the GBP L2 BD and L3 RD, 2 GBP external EP in EPG-1, 2 external subnets with sclass 200 and 300, Contracts allowing full communications between the 2 external subnets. DUT1 tested with virtual with VF enabled.

  • [Ver] TG verification: Test IPv4 packets are sent in one direction by TG on link to DUT1; on receive TG verifies packets for correctness and drops as applicable.

  • [Ref] Applicable standard specifications: IEEE 802.1q.

 Test Name 

 Status 

 64b-avf-dot1q- 
 l2bdbasemaclrn-gbp-dev

PASS

eth2p-avf-dot1qip4-l2bdbasemaclrn-dev

IPv4 routing with IEEE 802.1Q test cases

  • [Top] Network Topologies: TG-DUT1-TG 2-node circular topology with single links between nodes.

  • [Enc] Packet Encapsulations: Eth-IPv4 for IPv4 routing. IEEE 802.1Q tagging is applied on links between TG-DUT1.

  • [Cfg] DUT configuration: DUT1 is configured with IPv4 routing and two static IPv4 /30 route entries. DUT1 is tested with virtual.

  • [Ver] TG verification: Test IPv4 packets are sent in one direction by TG on link to DUT1; on receive TG verifies packets for correctness and drops as applicable.

  • [Ref] Applicable standard specifications: IEEE 802.1q.

 Test Name 

 Status 

 68b-avf- 
 dot1qip4-l2bdbasemaclrn-dev

PASS

eth2p-ethipv4-l2bdbasemaclrn-dev

L2 bridge-domain test cases

  • [Top] Network Topologies: TG-DUT1-TG 2-node circular topology with single links between nodes.

  • [Enc] Packet Encapsulations: Eth-IPv4 for L2 switching of IPv4. Both apply to all links.

  • [Cfg] DUT configuration: DUT1 is configured with L2 bridge-domain switching.

  • [Ver] TG verification: Test IPv4 packets with IP protocol=61 are sent in both directions by TG on links to DUT1; on receive TG verifies packets for correctness and their IPv4 src-addr, dst-addr and MAC addresses.

  • [Ref] Applicable standard specifications: RFC792

 Test Name 

 Status 

 64b-ethipv4-l2bdbasemaclrn-dev

PASS